This is the Futaba 9CAPS PCM Computer Radio with the
R149DP 9 Channel PCM 1024 Receiver.
This version does not include servos.

FEATURES: Enhancements to all three modes over the original 9C series include;
Glider Mode;
In addition to the Basic offset trim, three new offsets are
offered (launch, thermal and speed) with camber that can be
customized for each
Four camber mixes can be set up on one screen and programmed to
any of the variable dials
Airplane Mode;
With either selectable switch using channels 5, 7 or 8 fliers can
set up a two rate or a three rate GYA gyro system
Air brake is now switch-selectable
Helicopter Mode;
Throttle Curve and Pitch Curve now feature a delay for smoother
transition from hover to idle-up and better control
Throttle Hold and Idle-Up can be assigned to any switch that
feels more comfortable to the pilot
12 model memory expandable to 18 total with included CAMpac module
All functions are assignable
3 function timer-up/down or to keep track of total flying time-and
can be programmed to any of the switches, the power switch or the
throttle stick
Full functionality trainer system
PCM or PPM switchable

Airplane Programmable Features; Heli Programmable Features;
7 usable programmable mixes plus 3 usable programmable mixes plus
Aileron Differential Governor Mixing
Airbrake (w/delayed elevator 5 Point Throttle, Pitch and
Flaperon and Flap Trim Revolution Curves
Elevator Flap Mix Hover-Throttle Mix and Hover-
V-Tail and ELEVON Pitch Mix
4 Programmable Snap Rolls Trim Delay
Throttle-Needle Mixing 3 Idle-Up Conditions
Twin Elevators Options Throttle-Needle Mixing
2nd Channel Aileron Select Gyro Mixing
Offset Mixing
Sailplane Programmable Features;
7 usable programmable mixes plus
Single/Dual Flap Servos
Flap Aileron/Aileron Flap
Elevator Flap
Aileron Differential
Butterfly Mixing
_ Start (Launch) Preset
Speed Preset

INCLUDES: One 9CAPS Transmitter with frequency flag set, manual, transmitter
and receiver crystals and;
R149DP Receiver
NT8S700B 700mAh Transmitter Battery, FUTM1460
NR-4J 600mAh Receiver Battery, FUTM1280
FBC-19B(4), FUTM1830

REQUIRES: Servos depending on application

SPECS: Transmiter T9C Super:
Operating System: 2-Stick, 9-channel, PCM1024
Modulation: FM(PPM) or PCM, switchable
Power Supply: 9.6V, NT8S700B
Current Drain: 280mA

FP-149DP Receiver Narrow Band: 20Hz
Power Requirements: 4.8 to 6.0V (shared with servos)
Length: 2.19" (55.5mm)
Width: 1.00" (25.5mm)
Height: .089" (22.5mm)

FBC-30B(4)
Input: 120V AC 60Hz 6.2W
Output: Tx 11.6V DC 110mA, Rx 5.8V DC 150mA

COMMENTS: The 9C Super differs from the standard 9C in that the Super's glider
mode offers three offsets that can be customized, launch, thermal,
and speed with camber. The four camber mixes can be set up on
screen and programmed to any of the variable dials.
The Airplane Mode offers a selectable switch using channels 5, 7 and
8. All can be set up as a 2-rate (up or down) or a 3-rate
(up/center/down) and a gyro gain menu.
The Heli mode offers throttle and pitch curve delay for smoother
transition from hover to idle-up. The throttle hold and idle up can
be assigned to any switch.

For additional helpful information, consider purchasing the
Traplet Publications Futaba 9C The User's Guide, TPNZ1009.